Saturday, 3 August 2013

Fabricating a Replacement Pendulum Hanger

The movement for which this was fabricated was made by M Bauerle ca1925 and is of a very high quality. A 'make do' pendulum hanger was being used, however having serviced and repaired the movement I was keen to ensure it was restored to as an original state as possible. Finding an original brass pendulum hanger was not going to be likely at all. Thankfully a fellow friend in horology had the same movement and kindly forwarded details of the pendulum hanger on his movement (first pic below). The first piece to be made was turned on a watchmakers lathe, using a hand held graver (second pic). This part would have the pendulum leader's hooks over its spokes.

           

3mm brass rod was used for the hanger's length; 5mm brass rod for fabrication of the hangers top hook, the section that sits between the crutch forks and the lower part where the pendulum is actually hung. The first pic below shows the nearly completed bottom section of the hanger and the section that sits between the crutch forks. The second picture shows the early stages of the hanger's hook fabrication. The only part of the hook worked in the lathe was the tapered end, which also had a 3mm hole drilled through it in order to receive the 3mm brass rod.



The hook was shaped and formed by hand using a jewellers hand scroll saw and very fine files. The final finish to all parts was achieved with P7000 grit wet and dry paper.

                      


The pictures below show the bottom part of the hanger ready to take the pendulum, and the completed unit ready for fitting to the movement.







       

Monday, 29 July 2013

Longcase Clock Movement ca1830. Service and Repair.

This is a typical movement of the period. Many of these movements were made in foundries as 'kit form' and sold to clock makers. Though it required a great deal of skill to produce a working movement.     

There was a great deal of wear through out the movement. Notably the pivots showed significant wear, beyond what could be rectified by re-facing and burnishing. Below are a few examples.

      
           

Six pivots were found to require replacing. The worn pivots were cut away and new holes centred and drilled into the ends of the arbours. Followed by new pivot steel fitted into the holes, faced, polished and burnished. The picture below shows a repaired pivot.


Every pivot hole in the movement plates required attention, worn over time by the rotating pivots. The first picture below shows marks on one of the movement plates highlighting what side of the pivot holes are worn. Before a brass bushing can be fitted in these to make good the wear, the holes must be re-centred and reamed out. Accurate re-centring ensures that the wheels and pinions engage by the correct depth.  The second picture below shows a centred and reamed hole in the plate ready to accept the new bushing for the main wheel arbour. 


                      

The main wheel arbours are the largest in the movement and bear the weight of the 12lb lead weights. The bushings need to be a tight tapered from the inside, and be peened, see first picture below, into a slight chamfer  the newly reamed hole to prevent them shifting out of the hole, especially during winding of the movement. Following this it can be filed flat and finished in order to make the finish the repair to a high quality and original condition.

               


The first picture below shows the re-bushed strike train. All wheels are able to turn freely and engage at the correct depth. The same work was carried out for the going (time) train. Other pictures show the movement restoration complete and ready for testing for two weeks before being fitted back into the clock longcase.